BEST WAY TO SPLICE TRAILER WIRE HOW TO
BEST WAY TO SPLICE TRAILER WIRE PLUS

Most older American cars were this way - they used the same bulb for the brake light and turn signal, so the trailer lights were always done the same way. If you just apply the brakes without the turn signal on, the trailer nees to see a steady signal in both the green and yellow wires. For a right turn with the brakes on, it's just the opposite, steady in the yellow and flashing in the green. In this video I go over 10 different ways to repair or reconnect a chewed or damaged elect.

BEST WAY TO SPLICE TRAILER WIRE HOW TO

So when you have the left turn signal on and apply the brakes, the trailer needs to see a flashing signal in the yellow wire and a steady signal in the green wire. How to splice or connect broken and cut electrical wires together. Today I am discussing how I splice 3 wires together to make a safe, reliable, and strong electrical connection. On the trailer, the brake lights and turn signals share the same bulb so you need to provide three signals: On the car you have four signals that you need to use: Always run a ground wire from the frame of the vehicle (not from the hitch or bumper) to the trailer.

BEST WAY TO SPLICE TRAILER WIRE PLUS

trailer, then the best method is wiring them in parallel. So technically, you need only three wires to the trailer plus a ground wire. The converter combines the signal for the trailer but prevents the combined signal from back feeding the other side on the car. solution, including custom wiring, splice-in wiring and replacement wiring. Soldering is one of the most secure methods if you do not want to do any splicing. Use a wire jacket or something else around the wires. Protect the wires going from the trailer to the tow vehicle. Also, test, test, test all the connections.

Connect each wire securely, and button them all up well.

(how to solder: using soldering iron, how to crimp butt connectors: using crimping. Make sure that you keep your electrical connections secure and free of moisture by wrapping them in electrical tape and/or using Liquid Electrical Tape, SWC50122. The trailer lights and wires depend on that connector, so make sure wires are soundly attached internally. The issue is the seperate turn signal bulbs on the car vs the combined brake/turn bulb on the trainler. Stripping back the wire without cutting it and wrapping it with the pigtail and soldering it is another option again sealed with liquid tape and electrical tape. Splicing wires using various tools and methods, discussing pros and cons.

Best way to splice trailer wire